Cable adapter - XT60 female to XT30 male. Use this to charge your XT30 batteries on a charger equipped for XT60 batteries. Specifications:
|
The FULLSEND 3S 450mAh 75C Lipo Battery is lightweight and very compact size. . The Lipo fits into the iFlight CineBee whoop and TurboBee whoop. This battery increases flight time significantly and it also provides a little more power over the stock battery. Features : * Advanced battery technology doubles your device's performance time* High discharge performance and high energy...
*Not available for overseas shipment A new upgraded version of BONKA FPV performance U2 batteries series, employing the latest Silicone Graphene (SI GR) composition for added consistent explosive power - Ultralight - Higher reliability - Remarkable performance Specifications: Cells 6S Capacity 1300mAh Discharge 100C (130amp) Nominal Voltage 22.2V Cell Configuration 6S1P Connection XT60 plug Dimension W50mm x H34mm x L75mm Weight 240g * For those in the know and seek...
*Not available for overseas shipment Awesome new pack from Bonka! These packs take the beating, even from the more abusive setups like 2206-2600s and 5051x3 props! Specifications : Capacity 1300mAh Type 4S1P / 14.8V / 4 cell lithium polymer Constant discharge 95C Burst discharge 190C Charge Rate 1-3C recommended, 5C max Power Connector XT60 Size 33 x 34 x...
These anti-slip battery pads provide grip surface between the battery pack and frame, prevent slippage of LiPo battery mid-flight. To keep the pad contact surface tacky, rinse with water or wipe with a wet cloth. Available in two sizes. Specifications: Material Soft silicone Colour Black Size 65mm x 25mm x 1mm, 100mm x 30mm x 2mm Mounting 3M self-adhesive on...
These battery pads provide excellent grip between the battery pack and frame, prevent slippage of LiPo battery mid-flight. To keep the pad contact surface tacky, rinse with water or wipe with a wet cloth. Specifications : Material PU based Gel Colour Clear Size 50mm x 50mm x thickness 3mm Note use scissors to cut to size before peeling the clear protective...
A complete battery retention kit for racing frames with bottom mounted batteries, it comes with non-slip silica gel pad mounted on carbon fibre plate to keep the battery in place during flight and provides protection when landing. Specifications : Material 3K high strength carbon fibre board Thickness 1.5mm Anti Slip Pad Silicone gel pad with self adhesive Size 42 x...
Light weight TPU 3D printed designed for racing frames with bottom mounted batteries, it protects the battery from ground hits when in low level flights or when landing. Specifications : Material 3D printed TPU Colour Yellow, Red Front Incline Angle 30 degrees Fit Type 1 - Red (200 - 250mm frame) Type 2 - Yellow (110 - 130mm frame)...
Quality AMASS XT60H battery connectors come pre-soldered with 12AWG gauge soft silicone for direct connection to flight controllers, BEC or 4-in-1 ESC. The sheath at the solder connection provides strain relief for the solder joints and added protection against shorts from damaged insulation near the solder joints that may damage your LiPo batteries. Specifications: Connector AMASS XT60H male with connector sheath Connector Material...