• SKU:
SGD$59.50

 The Airbot OMNIBUS Fireworks V2 flight controller uses the ICM20608 over SPI for the best possible flight performance. With onboard damping box, the ICM20608 runs perfectly under 32k Gyro loop. Also onboard is a barometer and AB7456 OSD chip for BetaFlight integrated OSD.

Revobee32 V2 supports 3-6s LIPO direct input, build in Hall Current Sensor and Power Filter too.

The on Board PDB is tweaked by using 12-Layer PCB design with only 0.2-0.5 mohm internal resistance

Key Changes on V2:

-Tantalum Capacitors can be added to the board (not included)
-Solder pads added for SmartAudio and Camera Control (next to Video pads)
-The orientation of IMU FPC optimized
-Gyro ribbon cable redesigned to fit without extending outside the board
-Added an 8v BEC and LC Filter for the camera and VTX power
-Low resistance Hall current sensor
-Additional capacitors for reduced electrical noise
-Improved solder pads
-5 UART ports

Click here for manual and wiring diagram

Specifications:

LiPo 2-6S
MPU STM32 F405 MCU
Barometer onboard
Gyro ICM20608 Over SPI Bus DMA mode (up to 32k loop), mounted in damping enclosure box
Firmware target Betaflight, OMNIBUSF4FW (OBFW) 3.4
OSD Betaflight OSD
BEC

5V 1A BEC output (buck),

8V 1A LC filter for camera power (buck)

Voltage input 3-6S LiPo
Rx support 

SBUS, IBUS, DSMX, SUMD

 (SBUS Serial RX ON UART 1 – RC pad)

Accessories connection  Buzzer pad, LED pad, voltage monitor, built-in Hall current sensor, BLHELI 32 bit telemetry pad
PCB Professional grade 12 layer, 0.2-0.5mΩ internal resistence
Dimensions  36mm x 36mm x 10mm with a mounting hole of size M3 30.5mm x 30.5mm
Weight 12.4g

 

Click here for manual and wiring diagram