• SKU:
Based on HGLRC's proven flight control platform; the Airbus, specially designed for use with 4in1 ESCs board and a straightforward connection with other electronic components.The included rubber grommets removes the need for additional soft mounting hardware.

Compatible with most 4-in-1 ESC but designed to be pair with HGLRC DinoShot 60A BlHeli 32 4 in 1 ESC

Discount for ordering as a stack, click on price dropdown.

Click here for wiring diagram.

Specifications : 
Type F4 with 5V BEC
CPU STM32F405RGT6, dual 8K
Current Sensor NA, BLHeli32 ESC dependent
Firmware Target Betaflight 4.10 :  HGLRCF05AS(HGLR)
OSD Betaflight
On-Board Flash 16M
RX Support SBus/PPM/DSMX
UART Breakout UART3, UART6, UART1 (SBus Serial RX1)
Other connection breakout Cam, VTx, LED, Buzzer, PPM, DSMX, RSSI, Motor 6, 3.3V and 5V
Input voltage 2-6S
BEC Output 5V @ 3A
Size 36 x 36 mm, mounting holes M3 30.5mm
Weight 8.3g
Note Designed for use with 4in1 ESCs board, PDB required if using individual ESCs

1 pc × HGLRC Airbus F4OSD Flight Control Board

1 pc × SH1.0 8PIN 60mm Cable

4 pcs × soft mounting rubber grommets

4 pcs × nylon standoffs


Click here for wiring diagram.

TR Tip: If your FC does not come with a vibration isolated gyro, consider soft mounting to maximise the performance of your FC;  use O-rings to sandwich the FC at each of the 4 mounting holes or use rubber bobbins standoffs, especially when running fast cycle timings.

A low ESR capacitor of sufficient rating (eg 1000uf/35Volts for 4S), across the FC battery pads is helpful against electrical noise that may compromise FPV feed.To avoid grounding issues, do not use metal standoffs for FC.

Hot glue small gauge wires, such as ESC signal wires and FPV components connections at the solder joints for strain relief, this reduces instances of broken connections due to constant vibration or movement of the wires. The hot glue should cover a bit of the wire insulation near the solder joint and the solder joint itself.